By 25 September 2010 2 Comments Read More →

Buying Guide : Rover Metro/100

Fancy a K-Series Rover Metro or 100? Here’s what to look out for…


Years produced: 1990-1998
Body style: 3-door, 5-door hatchback
Engine options: 1120cc K-Series inline-four
1396cc K-Series inline-four 8V (76bhp) and 16v (95, 103bhp)
1360cc Peugeot TU diesel inline-four
1527cc Peugeot TU diesel in-line four
Transmission options: 4-Speed manual, 5-speed manual, CVT automatic, front wheel drive

Brief overview

1990 saw the introduction of the Rover Metro, and at a shot, it transformed Rover’s baby from class loser to class leader. The suspension revisions, and the award winning K-series engine ensured that the Rover got rave reviews from the motoring press.

Initially available in 1.1 and 1.4 8v carburettor and 1.4 16v SPi versions, the range was expanded in 1992 to include a 1.4 diesel. At the same time the 1.1 and 1.4 8v models gained single-point injection and the 16v multi-point injection.

By 1995, the Metro was beginning to get outclassed. Rover had planned the R3 (became the 200/25), but this model was moved up-market to the small family hatchback sector. So to keep a presence in the supermini sector, a reskin was done on the Metro. Relaunched as the 100, the car had a re-skinned front end, but it was obvious to everyone it was the same old Metro. Nethertheless, it still sold reasonably well and ad the new 1.5 diesel engine from the Peugeot 106 to replace the 1.4. This was changed in 1996 by the publiction of the Euro-NCAP test results. Sales plummeted, and the death knell sounded 2 years later.


What to look for

Engine & transmission:

The K-Series engine is generally reliable, but does have a tendancy to leak oil. Head gaskets are known to be weak, and will eventually go even on a well maitained car. If this is not rectified immediatly many cars will just go on, but many will need a new head later. It is in any case expensive not to repair this immediatly, as the coolant hoses will need replacement when in contact with oil for too long. However, if the car has been treated properly (regular serviceing, correct coolant strength, allowing engine to warm up before hard revving,) they should be OK. (check for oil in coolant and water in oil). GTa and GTi models are very likely to have been through a hard life, so a service history is essential on these models. Make sure the cambelt has been changed at 60,000 miles.

There are no major issues with the Peugeot sourced TU engine.

The R84/R85 manual boxes are generally fine in the Metro application, however they can make some noise from the input shaft bearing, and can crunch into reverse. This is nominal, and shouldn’t give cause for concern. It is also worth noting that it can cause problems on the higher powered cars; there have been cases of broken gears. Early gearboxes can leak oil through the breather (which could be replaced with the later breather).

Suspension, steering & brakes:

The Moulton Hydragas setup on the R6 is a joy, and really does give a big-car feel to a small car, however watch for the car being down on one side (particularly at the front) as this could indicate a worn hydragas displacer, however it could just need a pump-up.

Check the rear radius arms for play (an MoT failure) – if these have not been properly maintained, you will be able to easil spot an offending car by its negative camber angle on the rear wheels. In many cases then the rear arms are not saveable by this time and will need expensive replacement.

This is also the same for the front top arm: these have grease nipples and are frequently forgotten.

The steering is generally very direct, with no power assistance. Main things to check for are worn gaiters.

Brakes are generally OK, however the handbrake is manually adjusted and the adjusters have a tendancy to stick. Some WD-40 and a quality brake adjusting spanner should free this off.

Body & chassis:

The main enemy of any Metro/100 is rust. Rear wheel arches, floorpans and outer sills are known to be weak spots. Get the car on ramps and check the floor/sills for bodged repairs. Rear repair panels are commonly available (and cheap), so there is NO excuse for bodging here.

Interior:

Generally very hard-wearing but more visible on lighter coloured interiors.

Electrical system:

Generally reliable. A nice simple system produces few problems. however on later Metros (’93-95), ensure that if there is no remote keyfob, the alarm/immobiliser has been disabled, as the immobilser ECU is under the facia, and the facia will reqiure removal to access this.

On Rover 100s ensure the 4-digit immobiliser code is supplied (about £10 from a dealer) to allow the alarm to be de-activated should the remote keyfob fail.

On the 16v versions the alternator suffers the heat build-up from the exhaust manifolds and will eventually pack up – look out for the heat shield of the alternator. Engine ECU’s are known to stop working at about 10 years. Central locking and electric windows can give additional trouble.


Summary

A cheap first car that is tremendous fun. Generally easy to work on for a DIYer and the GTi is reasonably quick. The diesels offer good economy and the 1.1 is suprisingly nippy. The choice model is the 1.4 GS/GSi, which is again moderately quick, but has the best trim.


With thanks to Chris Mills and Alexander Boucke for compiling this article.

Keith Adams

About the Author:

Created www.austin-rover.co.uk in 2001 and built it to become the world's foremost reference source for all things BMC, Leyland and Rover Group, before renaming it AROnline in 2007. Is the Editor of the Parkers website and price guide, formerly editor of Classic Car Weekly, and launch editor/creator of Modern Clsssics magazine. Has contributed to various motoring titles including Octane, Practical Classics, Evo, Honest John, CAR magazine, Autocar, Pistonheads, Diesel Car, Practical Performance Car, Performance French Car, Car Mechanics, Jaguar World Monthly, MG Enthusiast, Modern MINI, Practical Classics, Fifth Gear Website, Radio 4, and the the Motoring Independent... Likes 'conditionally challenged' motors and taking them on unfeasable adventures all across Europe.

2 Comments on "Buying Guide : Rover Metro/100"

Trackback | Comments RSS Feed

  1. Uriah at GH says:

    Is there any reliability differences with the diesel. Is the head gasket still faulty?

  2. Dave says:

    Great write up, I must add that i myself have owned 6 rover 100,s over the years and every one of them never failed an mot , never blown a head gasket and
    only one of them had minimal rust on the rear arch, If you grease the suspension arms front+rear every year you wont have any problems.
    I am now on my 7th 100 ascot and its a little gem, its in mint condition and is very reliable, I wont hesitate to just jump in it and go on a 200 mile trip.
    Well maintained these little rovers are the best little runaround you can buy.
    I just wish i could go and buy a brand new one but unfortunately they are no more.

Have your say...